Enable and set up ScanMyLead for an event

This article explains how to enable ScanMyLead for your event and set up the app with languages, a custom domain, and your branding.

REQUIREMENTS

Before you start, you need:

• an event for which ScanMyLead has been booked
• access to the event in the AirLST Suite

ENABLE SCANMYLEAD

1. Open your event and select ScanMyLead from the menu.
2. Click Settings and select the General section.
3. Turn on ScanMyLead is active.
4. Under Scan from and Scan until, specify the period during which scanning is permitted.
5. Click Save.

Under Audit retention in days, specify how long entries are retained in the audit log. The default is 90 days.

LANGUAGES

Under Settings > Languages, specify which languages the app and lead form are offered in. When ScanMyLead is enabled, your event’s languages are imported once. Changes made here apply only to ScanMyLead.

• Enabled languages: Your booth staff can switch the app between these languages. The texts in the lead form can be translated into each of them.
• Default language: The language in which the app starts and the fallback for untranslated texts.

CUSTOM DOMAIN

By default, your team accesses the app through an AirLST address. Under Settings > Domain, you can make the app available through your own domain instead. 
Enter the domain and click Save.

APPEARANCE

Under Settings > Appearance, customise the app to match your corporate design. These settings only affect the scanning app, not the administration area in the Suite. A preview shows you the changes immediately.